LZ Dental Lab 750W 2 in 1 Dry/Wet Model Trimmer Cutting Machine

LZ Dental Lab 750W 2 in 1 Dry/Wet Model Trimmer Cutting Machine

The model trimmer is used to trim dental plaster models. The machine is made entirely of cast aluminum and the angle is adjustable between 0-20°.

Specifications:
Voltage:220v/50hz±10%
Power:750W
Maximum load:4.5kg
Water pressure:0.5-2kg
Dimension:29x27x17cm
Weight:26kg;

Instruction
Unpack the package, check if all the accessories are inside. Read this manual carefully before using.
Fix the model trimmer to bench with one screw on each leg to avoid shaking. Tighten all the screws on the machine
Then tighten the water pipe and the joint tightly to avoid breaking off, which might cause water splashes and damage to the motor.
Connect the power supply and check for abnormal noise from the motor, and inspect the grinding wheel. If the effect is not satisfactory, adjust the water pressure.
Input water.
The trimmer can be adjusted which makes it easy and convenient. The angles can be adjusted by more than 20°, the trimmer angle can be within 75°-105°.

Caution:
1. Water pressure less than 2kg/cm
2. Do not use the machine without water,otherwise it will damage the abrasive disc.

Contact Information:
Live Support: Chat with us online
Email: service.alandental@gmail.com
If you have any problem, please do not hesitate to contact us.

Shipment Note:
If your package shipped by Express Delivery, please give us a valid delivery phone number, and also a full and accurate shipping address.

How to Buy from Alandental?